Comtech EF Data RCS10 User Manual
Page 74

RCS10 Redundant Communication System
Operation
TM058 - Rev. 2.3
Page 3-27
- Press 'ENT' button.
- Press 0, 0, 5 (5 seconds) and '--->' soft key and continue until all modems are set for a 5
second failure delay before backup.
- Press 'ENT' button.
e. Set RCS10 as follows to select two 1:N systems with one modem being covered by both
backups:
- Press 'CONFIG SW' button.
- Press 'BU1 MODE' soft key.
- Press 'REVERTIVE' soft key. (Non-revertive could be selected as well if desired).
- Press 'BU2 MODE' soft key.
- Press 'REVERTIVE' soft key. (Non-revertive could be selected as well if desired).
- Press 'NEXT' soft key until 'AUTO B.U. ASSIGNMENT SUMMARY' appears on display.
- Press 'SET BU1' soft key.
- Press '<---' or '--->' softkey to move through the modems and press 'TOG MODE' softkey
until modems 1, 2, 5, 6, 7, 8 show 'md'.
- Press 'ENT' button.
- Press 'SET BU2' soft key.
- Press '<---' or '--->' softkey to move through the modems and press 'TOG MODE' softkey
until modems 3, 4, 7 show 'md'.
-
Press 'ENT' button.
The following display should appear:
1
2
3
4
5
6
7
8
BU1
md
md
md
md
md
md
BU2
md
md
md
PRIORITY
2
3
3
2
6
5
1
4
- You may at this point set desired priorities for the modems using the 'PRIOR' soft key.
- Press the 'NEXT' soft key.
- Press 0, 0, 5 (5 seconds) and '--->' soft key and continue until all modems are set for a 5
second failure delay before backup.
- Press 'ENT' button.
- Press 0, 0, 5 (5 seconds) and '--->' soft key and continue until all modems are set for a 5
second failure delay before backup.
- Press 'ENT' button.
f. To inject faults for testing Automatic Backup, or to force an Auto Backup of a modem,