Comtech EF Data RCS10 - Manual (Page 33)

Appendix A RCS10 Technical Specifications
Page A-1
Section 2 - Installation
2.0 Installation Requirements
This chapter instructs the user in the methods for setting up and installing an RCS10 Redundant
Communication System into a Satellite Modem system.
2.1 Unpacking the System
Unseal the shipping cartons taking care not to damage the cartons, the packing material or the
equipment inside. The cartons and the packing material should be saved in the event that an
RCS10 will need to be reshipped. Examine the exterior of the units for any possible shipping
damage.
2.1.1 List of Items
Carefully remove the units from the cartons. In addition to this manual, be sure that the following
items are present:
•
RCS10 Redundant Communication System
•
2 AC Power Cords
•
RCS10 System Test Data Sheet
2.1.2 In Case of Shipping Damage
If any shipping damage is discovered on any of the above listed equipment, promptly contact the
transporter and file a damage claim. The shipping company is responsible for any damage caused
during shipping. Radyne ComStream Corporation should also be contacted.
Damage as a result of transportation is not covered under the Radyne ComStream Corporation
Warranty. Refer to the Warranty section in the front of this manual for further information.
The procedure for returning faulty or damaged equipment is contained in the warranty section in the
front of this manual.
2.1.3 Test Data Sheet
Each RCS10 Redundant Communication System is shipped with a Test Data Sheet. This report
contains information on the results of the Switch quality control testing. The report also includes
information pertaining to the system settings that were made at the factory. Radyne ComStream
Corporation recommends that the user save this report for future reference.
2.2 Site Considerations
Adequate site planning and preparation simplifies the installation process and results in a more
reliable system.
The user should ensure that the site has adequate electrical power, environmental controls and
protection against sources of electrical radiation and interference.
2.2.1 Power Sources
The power sources should be properly grounded and as free as possible from electrical interference.
If a redundant configuration is to be used, then each power cord on the RCS10 must be plugged into
its own separate power circuit. Each circuit must have its own independent circuit breaker.
Grounding is achieved automatically when the three-prong power plug is inserted into a power
receptacle. This should be checked by testing that there is no voltage present between the chassis
of the Switch and the power line ground.