Comtech EF Data RCS10 - Manual (Page 17)

Addendum RCS10 Modem and Redundancy Control System
TM058 - Rev. 2.3 xvii
Demodulator Opcode <240CH>
Change Status Bytes <1> Alarm 5 to:
(Bit 0 = Trellis Decoder Lock, Bit 1 = FM DSP Lock Mask, Bit 2 = T1 signaling fault, Bit 3 = Turbo Codec
lock fault, Bits 4 – 7 = Spares)
Add to the end of Status Bytes:
<1> Spare
<4> Symbol Rate
(Binary Value, 1bps steps)
Demodulator Opcode <2409H>
Change <2> Sweep Delay to:
(Binary value, 0.1 second steps. Reserved)
Change <1> Convolutional Decoder (18 =… to:
18 = Trellis 8/9 Rate, 19 = Comstream SEQ 3/4 rate 20 = TPC.793 2D, 21 = TPC.495 3D, 22 = TPC.325 3D)
Change <1> Alarm 5 Masks to:
(Bit 0 = Trellis Decoder Lock, Bit 1 = FM DSP Lock Mask, Bit 2 = T1 signaling fault, Bit 3 = Turbo Codec
lock fault, Bits 4 – 7 = Spares)
Demodulator Opcode <2A08H>
Change <1> Convolutional Decoder (18 =… to:
18 = Trellis 8/9 Rate, 19 = Comstream SEQ 3/4 rate 20 = TPC.793 2D, 21 = TPC.495 3D, 22 = TPC.325 3D)
Add to the end of Demodulator Opcodes:
Opcode: <2C0BH>
Command modem terminal emulation
<1> Emulation Mode (0 = Add viewpoint, 1 = VT 100, 2 = WYSE50)
Opcode: <2C0CH>
Command modem terminal baud rate
<1> Baud Rate (0 = 300 baud, 1 = 600 baud, 2 = 1200 baud, 3 = 2400 baud, 4 = 800 baud, 5 =
9600 baud, 6 = 19200 baud, 7 = 38400 baud)
Opcode: <2C0DH>
Command modem configuration copy
<1> Source Configuration (0 = current, 1 = configuration 1, 2 = configuration 2, 3 =
configuration 3, 4 = configuration 4, 5 = configuration 5)
<1>
Destination Configuration (0 = current, 1 = configuration 1, 2 = configuration 2, 3 =
configuration 3, 4 = configuration 4, 5 = configuration 5)
Note: Source and destination configuration configurations must be different. Error 0x441 will be
returned if they are the same.