Comtech EF Data RCS10 - Manual (Page 16)

Addendum RCS10 Modem and Redundancy Control System
TM058 - Rev. 2.3 xvi
B.1.4 Global Response Operational Codes
Change the last Modem Response Error Codes Description and Opcode of the first group to
MPARM_AUPCDEFPOWER_ERROR 0x43F.
Add the following Modem Response Error Code Descriptions and Opcodes to the bottom of the first group
(following MPARM_AUPCDEFPOWER_ERROR 0x43F):
MPARM_CONFIGURATIONSOURCE_ERROR
0x440
MPARM_CONFIGURATIONDESTINATION_ERROR 0x441
MPARM_CONFIGURATION_ERROR 0x442
B.2 Remote Port Packet Structure
Modulator Opcode <2400H>
Change <1> Convolutional Encoder (18 =… to:
18 = Trellis 8/9 Rate, 19 = Comstream SEQ 3/4 rate 20 = TPC.793 2D, 21 = TPC.495 3D, 22 = TPC.325 3D)
Modulator Opcode <2607H>
Change <1> Convolutional Encoder (18 =… to:
18 = Trellis 8/9 Rate, 19 = Comstream SEQ 3/4 rate 20 = TPC.793 2D, 21 = TPC.495 3D, 22 = TPC.325 3D)
Demodulator Opcode <2401H>
Change <2> Sweep Delay to:
(Binary value, 0.1 second steps. Reserved)
Change <1> Convolutional Decoder (18 =… to:
18 = Trellis 8/9 Rate, 19 = Comstream SEQ 3/4 rate 20 = TPC.793 2D, 21 = TPC.495 3D, 22 = TPC.325 3D)
Change <1> Alarm 5 Masks to:
(Bit 0 = Trellis Decoder Lock, Bit 1 = FM DSP Lock Mask, Bit 2 = T1 signaling fault, Bit 3 = Turbo Codec
lock fault, Bits 4 – 7 = Spares)
Change Status Bytes <1> Alarm 5 to:
(Bit 0 = Trellis Decoder Lock, Bit 1 = FM DSP Lock Mask, Bit 2 = T1 signaling fault, Bit 3 = Turbo Codec
lock fault, Bits 4 – 7 = Spares)
Add to the end of Status Bytes:
<1> Spare
<4> Symbol Rate (Binary Value, 1bps steps)