beautypg.com

Comtech EF Data RCS10 User Manual

Page 72

background image

RCS10 Redundant Communication System

Operation

TM058 - Rev. 2.3

Page 3-25

EXTEXC and the EXTEXC source to IDI since these are required modes to run EXTERNAL
FRAMING).

- Press 'NEXT' soft key until you get to the display where you can set 'TX D&I MAPPING'.

- Press 'COPY' soft key.

- Press 'UP' or 'DOWN' soft key until 'ROM8’ is displayed.

- Press 'CURSOR' soft key.

- Press 'UP' or 'DOWN' soft key until 'TX EDIT' is displayed.

- Press 'ENT' button.

- Press 'COPY' soft key.

- Press 'UP' or 'DOWN' soft key until 'TX EDIT’ is displayed.

- Press 'CURSOR' soft key.

- Press 'UP' or 'DOWN' soft key until 'TX ACTIVE' is displayed.

- Press 'ENT' button.

- Press 'NEXT' soft key. (See RX D&I MAPPING).

- Press 'COPY' soft key.

- Press 'UP' or 'DOWN' soft key until 'ROM8" is displayed.

- Press 'CURSOR' soft key.

- Press 'UP' or 'DOWN' soft key until 'RX EDIT' is displayed.

- Press 'ENT' button.

- Press 'COPY' soft key.

- Press 'UP' or 'DOWN' soft key until 'RX EDIT" is displayed.

- Press 'CURSOR' soft key.

- Press 'UP' or 'DOWN' soft key until 'RX ACTIVE' is displayed.

- Press 'ENT' button.

These settings load slot 1 with channel 1, 2 etc. To set specific Terrestrial time slot to a specific TX
Sat Ch, you would use 'EDIT' soft key.

b. Set RCS10 as follows to force a manual backup from prime #4 to backup #1:

- Press 'CONFIG SW' button.

- If BACKUP1 MODE: MANUAL you may skip the setting of manual.

- Press 'BU1 MODE' soft key to select BACKUP #1.

- Press 'MANUAL' soft key to place BACKUP #1 in MANUAL mode.

- Press 'NEXT' soft key until you reach 'MODEM SWITCHING STYLE' display.

- Press '<---' or '--->' soft key until 4 is highlighted.

- Press 'TOG MODE' soft key until modem 4 shows a 'U' (Unit or dependent switching).

- Press 'ENT' button.

- Press 'NEXT' soft key until 'FORCE MANUAL BACKUP' display appears.

- Press 'SET BU1' softkey.