Comtech EF Data CDM-840 - Manual (Page 170)

CDM-840 Remote Router Revision 2
Serial-based Remote Product Management MN-CDM840
7–24
Parameter
Type
Command
(Instruction
Code
& Qualifier)
Number of
Arguments for
Command or
Response to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 and 57)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code &
Qualifier)
Response to Query
(Target to Controller)
GE Link
Configuration
LC1= 1 byte Command or Query.
Sets or returns GE Interface mode in the form x, where:
0=Auto Negotiate
1=1000Mbps -Full Duplex
2=100Mbps – Full Duplex
3=100Mbps – Half Duplex
4=10Mbps – Full Duplex
5=10Mbps – Half Duplex
Example: <1/LC1=3’cr’
LC1=
LC1?
LC1*
LC1#
LC1? LC1=x
(see Description of
Arguments)
Actual
Negotiated
Port Speed
N/A None Query only.
Returns actual negotiated port speed in the form ab, where:
a = GE1 negotiated port speed.
b = management port negotiated port speed.
a, b have the following values:
0 = Link down
1=100 Full
2=100 Half
3=10 Full
4=10 Half
5=1000 Full
Example: <1/NPS?’cr’
N/A NPS? NPS=ab
(see Description of
Arguments)
Management
IP Address
IPA= 18 bytes Command or Query.
Sets or returns set the IP address and network prefix for the 10/100 BaseT
Ethernet management port, in the form xxx.xxx.xxx.xxx/yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Example: <1/IPG=192.168.001.004/24’cr’
IPA=
IPA?
IPA*
IPA#
IPA? IPA= xx.xxx.xxx.xxx/yy (See
description of arguments)
Management
Link
Configuration
MLC= 1 byte Command or Query.
Sets or returns Management Interface mode in the form x, where:
0=Auto Negotiate
1=reserved
2=100Mbps – Full Duplex
3=100Mbps – Half Duplex
4=10Mbps – Full Duplex
5=10Mbps – Half Duplex
Example: <1/MLC=3’cr’
MLC =
MLC?
MLC *
MLC #
MLC? MLC =x
(see Description of
Arguments)