Comtech EF Data CDM-840 - Manual (Page 128)

CDM-840 Remote Router Revision 2
Ethernet-based Remote Product Management MN-CDM840
6–60
6.4.4.5.5 Configuration | dSCPC (Dynamic Single Carrier per Channel)
This page is operational only when the optional dSCPC FAST feature and VIPERSAT
MANAGEMENT SYSTEM (VMS) is installed and enabled.
Use the optional dSCPC (Dynamic Single Carrier per Channel) FAST feature to enable dynamic
allocation and sharing of bandwidth among users.
Figure 6-30. Configuration | dSCPC Page
Load Switching Configuration
The acceptable/valid operating ranges for items in this section are provided in parentheses.
• Mode – Use the drop-down list to select operation as Disabled or Enabled. Click [Submit]
when done.
• Step Up Threshold (0 to 100) – Enter the percentage of bandwidth use that will trigger a
switch up from the present SCPC rate to a higher rate to ensure that there is sufficient
bandwidth available for current conditions. Note that this value must be greater than the
value specified for the SCPC Step Down Threshold. A typical setting for this parameter is
95%.