Code Blue TOOLVOX X3 - Manual (Page 43)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-154-F page 43 of 132
ToolVox® X3
Administrator Guide
Wait for Answer -
The amount of time the phone will try a number before resetting and dialing the next number 00-99.
Timer begins at button press.
Call Connected –
0 or 1, 0=when voice or DTMF is detected by the CB phone. 1=call is assumed connected
immediately and will not retry. (Non-ADA)
Call Loop Cycles –
Number of cycles the CB phone will cycle through the above Numbers if a busy tone is encountered.
Duplex Operation –
Audio operation of the CB phone. Half or Full. Half is generally much better in most situations. In
very load environments Full may be necessary so the mic and speaker are both on at the same
time.
Full Duplex Noise Cancellation –
If you use Full Duplex then you can increase Noise cancellation but may suffer some audio
degradation.
Answer Message Repeat –
Enabling will force messages after the guard answers to repeat until the in-call command 33 is sent
to the unit.
Acknowledge Beep Delay – The amount of time the phone will wait to play acknowledgment tones.
Designated value * 20 = time in milliseconds. Example Value 15=300ms.
Call In Answer Mode – In two way Audio the unit will answer and immediately go into 2 way talk
mode. In 2 way Audio – Password required, the unit will prompt the caller for a password before
entering 2 way talk mode.
Miscellaneous
DTMF On Time – DTMF tone duration: 1 to 3 = 100 to 200ms, 4 to 9 = 40ms to 90ms.
DTMF Off Time – Silence between DTMF tone duration: 1 to 3 = 100 to 200ms, 4 to 9 = 40ms to
90ms.