Using the battery, Connection for the cigarette lighter, General operation – Becker mamba.4 LMU plus User Manual
Page 26
26
>>>
GENERAL OPERATION
Using the battery
The internal power supply is via the
integrated rechargeable battery. The
rechargeable battery is maintenance-
free and does not require any particular
care.
You are alerted by a warning message
when the battery should be recharged.
After the alert, the device can still be
used for approximately 10 minutes
before switching off automatically.
Connection for the cigarette lighter
Connect the power supply via the vehicle
battery and the cable provided for the
cigarette lighter as follows:
> Grasp the connector of the connection
cable and insert it gently without force
into the connector socket of the
navigation device up to the stop, or in
the case of a device with an active
cradle, on the underside of the
supporting plate. (Model dependent,
this step is not required on navigation
devices with magnetic holders)
> Insert the adapter into the cigarette
lighter.
The connection on the motorcycle is
described in chapter “Installing
navigation device” on page 19.
Note:
Note that if the battery is completely
discharged, it may take up to a minute
before the device can be switched on
again.
Note:
In the event of a defective battery,
please contact your authorised dealer.
Note:
If the cigarette lighter has recently been
used and is still hot, wait until the lighter
socket has cooled down.
Note:
When the engine is switched off, the
power supply slowly discharges the
vehicle battery via the cigarette lighter!
Do not therefore operate the Navigation
device for long periods with the engine
switched off.