Avery Dennison 9400 Series Programmer Manual - Manual (Page 48)

•
If the field is an incrementing field, you can enter any
type of characters; however, only the numeric data will
increment.
•
Make sure the print data begins with a semi-colon (;).
•
Make sure each record ends with a record separator
(
p
).
•
Place a close brace (}) at the end of the last record.
NOTES:
1. Send the correct format to the printer before sending the
batch. Batch data that doesn’t have a defined format will
generate an error.
2. If consecutive batch data streams use the same format,
send only the changed data fields. See the following
section, "Using Previously Defined Print Data."
Using Multiple Batches with One Format
You can send multiple batches for any format previously
loaded into the printer. To do so, send the format to the printer,
then send as many batches as you want to print data on that
format.
This allows you to send multiple batches without sending a
new format with each batch.
Using Previously Defined Print Data
When sending multiple batches for one format, you can
"re-use" your print data. On consecutive batches, the data in a
field does not change, omit that field from the later batch.
When you leave out any field number that was specified in the
preceding batch, the data used in the preceding batch will print
on following batches until new field data is entered.
9400 Series Programmer’s Manual
4-32