Avery Dennison 9400 Series Programmer Manual - Manual (Page 27)

ROW
One to four digits to define the row
location of the field on the supply. This is
the distance from the the guide edge zero
point at the
bottom of the supply and the
bottom of the field.
The zero point is 1.5 mm or 0.060 inches
from the bottom of the supply. The bottom
of the supply is the edge that exits the
printer first.
This value is measured in tenths of
millimeters (TOMMS) and must be less
than the maximum length of the supply.
Values: 0-2032
COL
One to four digits to define the column
location of the field on the supply. This is
the distance from the guide edge zero
point at the
left edge of the supply and the
left edge of the field.
The zero point is 1.5 mm or 0.060 inches
from the left edge of the supply.
The unit of measurement is tenths of
millimeters. The range must be less than
the maximum width of the supply.
Values:
9425 0-508 (0 to 2 inches)
9445 0-1016 (0 to 4 inches)
9465 0-1016 (0 to 4 inches)
9474 0-1016 (0 to 4 inches)
M
essag
e S
tru
ct
u
res
4. Message Structures
4-11