Avery Dennison 9400 Series Programmer Manual - Manual (Page 19)

Error Notification
Data handling and error checking are resident in the printer. If
an error in transmission occurs, an error is displayed on the
printer keypad display. However, no message is sent to the
host computer and processing continues until the end of the
transmission.
Certain errors may put the printer in offline mode. See the
Messages Manual for a list of possible messages.
Data Transmission Errors
The printer displays errors that occur during data
transmission. Printer fault errors stop the machine, which
will not resume printing until the operator corrects the error
condition. All these messages take the system offline.
Incorrect Data Errors
The printer pauses when it receives incorrect data from the
host computer. During the pause, it displays a message
and beeps. After ten seconds, or when the operator
presses
E
, the printer resumes operation. Normally,
the printer loses the data that caused the error.
If the host or the communications line goes down during
transmission, the printer displays the message
Waiting for command terminator.
Press F1 to abort download.
If you press
!
, the batch or format data that was being sent
will be lost and must be retransmitted.
M
essag
e S
tru
ct
u
res
4. Message Structures
4-3