beautypg.com

Avalon Firestyles GreenStart Igniter 2 for Inserts User Manual

Page 5

background image

GreenStart Igniter 2 for Inserts:

Installation Instructions

(SKU 94400952)

Page 5 of 12

17601768.docx— 10/21/13

© Travis Industries, Inc.

Start Button Installation

Flush Wood Plus Arch Start Button Installation:

Drill a

9

/

64

” pilot hole approximately 2” from the flat end of the left side trim panel. Enlarge the hole with

the ½” drill bit.

Affix the GreenStart sticker over the hole.
Route the On/Off switch wires through the drilled hole and install the power button.

Attach the trim and panels, and connect the start button wires to the igniter assembly.
NOTE: The wires are color-coded and must be matched.

Flat End

Beveled End

NOTE:
Use a saw to remove a
7/8” x 7/8” notch from
the rear of the trim. This
will be used to route the
igniter cord.