Avalon Firestyles DVL GSR Firebacks - Manual

DVL GSR / 33 DVI Firebacks
96100150 Brick/Herringbone (2 Sided) 96100274 Handmade Brick
Page 1 of 2 17601421 - 12/1/14 Travis Industries, Inc.
Packing List
 Rear Fireback
 (2) Side Firebacks
Installation
The rear fireback is rectangular and must be placed right-side-up. Lay the
firebacks on a flat surface prior to installing to verify the grout lines are aligned.
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
NOTE On two-sided firebacks make sure to use the desired pattern.
1 Remove the glass frame and logs (see the manual for details).
2 Remove the burner (see the manual for details).
3 On the DVL GSR, bend the accent light down.
4 Install the rear fireback as shown below. The top slides behind the baffle and the bottom rests on the shelf at
the back of the firebox.
Slide the back fireback
behind the baffle on top
of the firebox then pivot it
into place. It rests on the
shelf at the back of the
firebox.
Handmade Brick (96100274) - Mortar Line at Top
Standard Brick (96100150) - Mortar Line at Bottom
5 On the DVL GSR, return the accent light to the correct configuration.