Avalon Firestyles 1-Piece Surround Panel - Manual

1-Piece Surround Panel (DVS/31 DVI)
Page 1 of 2 2/25/2014 17601666 © Travis Industries, Inc.
Compatibility
 DVS
Insert
 31 DVI Insert
Part Numbers
 DVS – 25” by 38”
96100318
 DVS – 28-1/2” by 40”
96100324
 DVS Custom One-Piece Panel (contact Travis Industries for Details)
Packing List
 Surround
Panel
 Right and Left Mounting Bracket
 (4) 10-24 Type F Thread-Cutting Screws
Arched Faces with Screens (2014 or later) Require Use of the Extended Position Notch
This surround panel has 2 notches. Notch position is
determined by the face being used (see below)
Standard Position – used for all faces except for the
new 2014 arched faces with screens. All other faces use
the standard position notch. If you are uncertain, use the
standard position.
Extended Position – used only for new arched faces
with screens (2014 or later). The extended position
allows room for the screen and eliminates the ½” gap to
the panel. The extended position notch positions the
insert ½” farther into the fireplace cavity.
Standard
Position
Extended
Position
Inside Fit Panels
The panels may be cut down in size and placed within the fireplace opening.
Rheostat and On/Off Switch Placement on 31 DVI
Install the rheostat and On/Off switch in the control panel under the firebox (see the Owner’s Manual for details).
Fireplace Sizing
When using the 1-piece panel, make sure to accommodate the additional space required inside the fireplace. See the
table below for details.
Fireplace Sizing Height Width Depth Protrusion onto Hearth
3-Piece Panels 19-1/2” 26-1/2” 15-1/8” 1-1/4”
1-Piece Panel 20-5/8” 29” 16-3/8” 0”
Routing the Power Cord
Because this panel fits flush against the fireplace facing, the panel does not have a notch allowing the power cord to
exit the fireplace. We recommend using the insert wiring kit (sku 97200315) to route power to the insert. Otherwise,
route the power cord behind the panel to the right side (the panel or fireplace may be notched, if required).