Avalon Firestyles DVS GSR Dancing-Fyre Burner - Manual

DVS GSR Dancing-Fyre Burner
Installation Instructions
(SKU 96900103)
Page 1 of 4 17601694.docx — 7/31/12 © Travis Industries, Inc.
Make sure to have the media kit and firebacks (if used) available at the time of
installation. Components from the media kit are used during burner installation.
Compatibility
 DVS GSR NB Insert  DVS GS NB (AU) Inbuilt
Packing List
Left and Right Ember Trays Air Deflector DVS Dancing Fyre Burner Assembly
Order of Installation
If using LP (Propane), convert the appliance prior to installing the burner (see owner’s manual).
Driftwood Log Set (94500571) or Fyre‐Stones Set (94700762)
When using Driftwood or Fyre‐Stones media, note that the only compatible firebacks are
stainless steel or enamel.
a) Remove the glass frame.
b) Disable the accent light
(see instructions on page 4).
c) Install the burner (see instructions on page 3).
d) Attach the air deflector (see instructions on page 4).
e) Install the firebacks (if used).
f) Install the media (see instructions included with the media kit).
Traditional Log Set (94500991) *
a) Remove the glass frame.
b) Install the burner (see instructions on page 3).
c) Attach the air deflector (see instructions on page 5).
d) Install the firebacks (if used).
e) Install the media (see instructions included with the media kit).
* NOTE: If using the Traditional Log Set with stainless steel or enamel firebacks, you will need to
conduct the following order of installation:
a) Remove the glass frame.
b) Attach the air deflector (see page 5).
c) Bend the accent light down.
d) Install the rear fireback. e) Bend the accent light up.
f) Install the burner.
g) Install the side firebacks.
h) Install the media.