Avalon Firestyles Gas/Pellet Remote Thermostat - Manual

Wall Thermostat
SKU 99300650
Page 1 of 3 2/2/11 - 17601040 © Travis Industries, Inc.
Compatibility
• All Travis Gas Stoves
• 33 DVI Insert
• 31 DVI Insert
• 564 SS and DF • 864 TRV, ST, and HO
• All Travis Pellet Stoves or Inserts
Packing List
• Thermostat
• Thermostat Wire (20’)
• (2) Screws (for attaching thermostat)
Installation Warnings
! Shut off power to the appliance and allow it to cool prior to installation.
! This kit must be installed by a qualified technician.
! Do not connect 110 VAC to the gas control valve or on/off switch on gas heaters or the thermostat
posts on pellet heaters.
Follow the instructions on the following pages for the type of model being addressed.
Wire Connection - Pellet Heaters
Attach the thermostat wire to the circuit board.
b
Swing the
panel
open.
d
a
Phillips
Screwdriver
Open the hopper lid and remove the
screw holding the right panel in place.
Route the wires up to the circuit
board and attach the quick-connects
to the thermostat posts (orientation
does not matter).
Bundle up any excess wire with a
lock-tie to prevent it from contacting
any hot or moving parts
If necessary, attach the
pellet stove connector
wires to the ends of the
receiver wires.
c