Avalon Firestyles DVS Double-Door Backing Plate User Manual
Dvs double-door backing plate, Dvs universal no panel face

DVS Double-Door Backing Plate
Small 95100060 Large 95100061 (Requires Double-Doors to Complete)
DVS Universal No Panel Face
Small 95100050 Large 95100051
Page 1 of 4
17601531 - 10/29/13
© Travis Industries, Inc.
Compatibility:
• DVS GSR
• 31 DVI
Sizing
Packing List:
• Face (Backing Plate)
• Left and Right Face Brackets
• Left and Right Mounting Brackets
• (6) 8-32 Keps Nuts
• (6) 10-24 x 1/2” Type F Screws
Width Height
Small
37-1/2” 23-1/8”
Large
40-3/8” 29”
Installation of the Rheostat and On/Off Switch (31 DVI Only)
When using this face you may install the on/off switch on the face (see instructions below) or on the control
panel (see manual). The rheostat must be installed on the control panel. See the directions below for details.
WARNING: Make sure to unplug the heater before installing the rheostat.
Make sure the wires leading to the on/off switch are firmly attached (they attach to the top and bottom posts
on either side of the switch -it does not matter which wire is on top). Route the on/off switch to the slot on the
upper right of the face (you will need to remove the lock-tie on the wiring harness). Remove the knock-out
and slide the switch into the rectangular slot until it locks into place.
Upper Right of Face
Remove the knob and nut from the rheostat. Insert the shaft on the rheostat through the circular hole on the
control panel and secure with the nut. Replace the knob.
Control Panel
(next to gas control valve)