Avalon Firestyles DVS Face User Manual
Dvs face installation – with screen (2014)

DVS Face Installation – With Screen (2014)
Wilmington Black 95100240 Wilmington Carbon 95100241 Rosario 95200121
Arched Black 95300191 French Cntry Black 95300195 Rect Black 95300196
Page 1 of 3
17601842 - 11/26/14
© Travis Industries, Inc.
Compatibility:
• DVS Insert
• 31 DVI Insert
Packing List:
• Face
• (4) 10-24 x 1/2” Thread-Cutting Screws
• Extended Convection Deflector (Arched Faces Only)
• Patina Touch-Up Kit (Patina Faces Only)
• (2) Insert Brackets
• (2) Face Brackets
• (4) 8-32 Nuts
Hand-Rubbed Patina Finishes
The optional patina finish is hand applied by a skilled artisan to permanently alter the metal colors and texture of the face.
Each face is individually hand-polished and fired in an oven which imparts unique color subtleties with no two finishes alike.
The patina finish on your face is a “living” color and will age and antique over time. Enjoy the timeless, rich luster of your
beautiful new face.
When Using an Arched Face You Will Need the New, 2014 Panels
The new 2014 faces include a screen barrier. On rectangular faces, the screen is submerged into the return flange on the
face. No additional depth is required when installing. Rectangular faces may be used with older panels.
On arched faces the screen is attached directly to the back of the face. This creates an additional ½” of depth. To
accommodate this depth, new surround panels were released in 2014 with two positions. The standard position is the same
as the earlier panels and is used on all faces except for the arched faces. The extended position locates the panel forward ½”
to allow for the face to fit against the surround panel. This positions the insert ½” farther into the fireplace cavity. These faces
also require use of the extended convection deflector (included with the face – see instructions below).
Standard Position Faces (may use older panels)
Extended Position (requires new, 2014 panels)
• Wilmington Black 95100240
• Wilmington Carbon 95100241
• Rosario 95200121
• Rectangular Black (FPX) 95300196
• Arched Black (FPX) 95300191
• French Country Black (FPX) 95300195
The 2014 surround panels have two sets of holes (3-piece panels) or notches (1-piece panel) - see the illustrations below.
Make sure the surround panels are installed in the correct position.
3-Piece Panels
1-Piece Panel
Arched Faces Require the Extended Convection Deflector
Arched faces include an extended convection deflector to direct
the convection air through the surround panel. Discard the
convection deflector included with the insert and install the
extended version as shown to the right (screws are included in
the insert owner’s pack). Before installing, the extended deflector
will need to be bent to match the shape of the stock deflector (use
pliers to bend).
Extended
Position
Standard
Position
Standard
Position
Extended
Position