Avalon Firestyles GreenStart Igniter 2 for Inserts User Manual

Page 10

GreenStart Igniter 2 for Inserts:

Installation Instructions

(SKU 94400952)

Page 10 of 12

17601768.docx— 10/21/13

Operating Instructions

Warnings

The igniter must be operated only with someone present. Improper operation may lead to smoke
entering the home.

MAKE SURE THE AIR CONTROL AND BYPASS ARE OPEN (IF APPLICABLE). FAILURE
TO OPEN THESE CONTROLS MAY LEAD TO SMOKE ENTERING THE HOME.

DO NOT OPEN THE DOOR DURING IGNITION. THIS MAY LEAD TO SMOKE ENTERING
THE HOME.

DO NOT PLACE YOUR HAND NEAR THE IGNITER OPENING. THIS AREA BECOMES
EXTREMELY HOT AND MAY CAUSE SEVERE BURNS.

Operating Tips

The compressor assembly will turn on for 30 seconds when it is first plugged in. This is normal.

Hardwood or un-seasoned wood may take longer to ignite. For this kind of wood you may need to
cut the kindling into smaller pieces.

Wood placement is the key to building a good fire. Experiment with different sizes of wood and
wood placement until you find a method that works best for your wood quality and kindling.

Make sure to place the wood within 1” of the igniter opening.

1. Place two pieces of wood front to back opening on the firebox floor (or ashbed) as shown below.

NOTE: These pieces should be placed to elevate the next course of kindling to a position next to the
igniter opening.