Avalon Firestyles Lower Panel - Manual

Lower Panel
DVS / DVL Insert EF II
96100340
© Travis Industries 17601429 Page 1 of 2 060320
CHECK CONDITION OF SHIPMENT
Upon receipt of this kit, check the condition of the packaging. Damage to the package should be noted on
the carrier's freight receipt. Any damage claims as a result of shipping must be handled through the shipper.
Travis Industries will provide assistance in resolving shipping claims or replacing items not included in the
package. Please report any missing items immediately.
COMPATIBILITY
• DVS Insert EF II with EF II Surround Panels • DVL Insert EF II with EF II Surround Panels
DVS – 4” by 6” 96100300 DVL – 4” by 6” 96100320
DVS – 8” by 10” 96100301 DVL – 8” by 10” 96100321
DVS – 10” by 13” 96100302 DVL – 10” by 13” 96100322
ITEMS NEEDED FOR ASSEMBLY
• 11/32" Wrench • Hack Saw (for cutting the trim)
• Nibbler, Electric Shears, or other device for cutting 20 gauge sheet metal
PACKING LIST
• Lower Panel • (2) Stud Plates • (4) 8-32 Keps Nuts • Side Trim (2 pieces)
INSTALLATION INSTRUCTIONS
! Turn the gas off prior
to installing.
1 With the insert in
place and hooked
up, install the side
and top surround
panels (do not install
the trim, rheostat, or
on/off switch).
2 Cut the the lower
panel following the
directions to the
right.
Panel Height:
Cut the lower panel to the desired height.
Panel Width:
Cut the following off each side:
• DVS Insert 4 x 6 Panels 5-1/2"
• DVS Insert 8x10 & Arch Panels 3-7/8"
• DVS Insert 10 x 13 Panels 1-7/8"
• DVL Insert 4 x 6 Panels 4-1/16"
• DVL Insert 8 x 10 & Arch Panels 2"
• DVL Insert 10 x 13 Panels - none -
See "Panel Width" above.