Audioscan Verifit - Manual (Page 23)

Verifit ® User's Guide Version 3.12  May 2015
Software updating
If your Verifit does not have a CD drive (serial number 4671 and higher) a USB flash drive was shipped with
your Verifit. It is required to transfer software updates from a PC to the Verifit. Please STORE IT IN A SAFE
PLACE. You may download the latest software from www.audioscan.com or request that a CD-ROM be mailed
to you. Instructions for transferring the software update from your PC to the Verifit will be included with the
software download or the CD-ROM.
If your Verifit has a CD-ROM drive (serial number less than 4671), you may download the latest software from
www.audioscan.com and burn it to a CD-ROM. Alternately, you may request that a CD-ROM be mailed to you.
To install the new CD-ROM:
1. Under Setup, select CD-ROM, then select Open CD drive.
2. Press the OPEN button on the door of the CD drive. The door should open.
3. Remove the old CD-ROM by pressing on the center spindle and gently lifting the outside edge.
4. Position the new CD-ROM on the spindle, printed side up, and press gently downward until it snaps into
place.
5. Gently push the CD drive door inward until it snaps closed.
6. Select and follow on-screen instructions.
If the CD drive door fails to open in step 2, switch the Verifit OFF and back ON and press the OPEN button on
the CD door within 3 – 5 seconds. The door should open. Switch the Verifit OFF and install the new CD-ROM.
Switch it ON and follow any on-screen instructions. If necessary to open the CD drive without power, insert the
end of a small screwdriver (or paper clip) in the hole near the light on the CD drive door.
Note that the CD-ROM must be present in the CD drive for normal operation
23