Artesyn PCIE-8120 Installation and Use (July 2014) - Manual (Page 88)

Miscellaneous
PCIE-8120 Installation and Use (6806800R89C) 88
#define DSP_IP_FINISH (DSP_IP_START+MAX_DSPS-1)
So, with current settings these IP addresses are used:
DSP0 IP : 192.168.76.201
DSP11 IP : 192.168.76.212
D.4.2 Requirements
The following requirements must be fulfilled to enable the demo application to run:
This demo application is compiled with Octasic SDK version 1.9.3.
The DSP image must have the Artesyn specific license file included. This means the DSPs must
be out of reset and the image downloaded via TFTP.
The IP address is not important, as the software uses raw sockets to communicate with the
DSPs.
D.4.3 Running Software
 New features
If any of these counters are non-zero a warning will be displayed at the end of each out
DSPs statistics list.
ulRxBadPktTypeCnt
ulRxBadRtpPayloadTypeCnt
ulRxBadPktHdrFormatCnt
ulRxBadPktLengthCnt
ulRxMisorderedPktCnt
ulRxLostPktCnt
ulRxBadPktChecksumCnt
ulRxUnderrunSlipCnt
ulRxOverrunSlipCnt
ulRxVocoderChangeCnt
ulRxCircularBufferWriteErrCnt
ulRxApiEventCnt
ulTxInBadPktPayloadCnt
ulTxTimestampGapCnt
ulTxTdmWriteErrCnt