Artesyn PCIE-8120 Installation and Use (July 2014) - Manual (Page 62)

PCIE-8120 Hardware Description
PCIE-8120 Installation and Use (6806800R89C) 62
A synchronous clocking scheme is used for the DSP building blocks to allow for task distribution
over several DSPs. All other components have individual clocking sources.
 Oscillators are EPSON SG-210 or equivalent types, +/-50ppm tolerance.
 Resonators are EPSON FA238 or equivalent types, +/-23ppm tolerance.
 Clock buffer device is TI CDCLVC1112.
B.6 Ethernet NIC - i82580EB/DB
The PCIE-8120 uses an Intel 82580EB/DB Gigabit Ethernet Controller to implement PCI Express
connectivity and thereby provides access for the Host system towards the card's resources.
This device supports up to four Ethernet ports with integrated MAC units and SGMII/SerDes
interface. The ports are connected to the Ethernet switch unit on the card. Also, see
Ethernet
Port Mappings on page 63 .The host interface supports a PCI Express v2.0 x4, x2, x1 link with
5Gbps and 2.5Gbps operation.
B.6.1 NV-Memory-NIC Configuration
The PCIE-8120 card stores configuration data for the Intel i82580EB/DB device on a local
EEPROM device. The configuration data for individual variants is according to port mapping.
See,
Ethernet Port Mappings on page 63 .
 MAC Addresses: factory programmed.
 Subsystem Vendor ID set to 0X1223 for Artesyn.
 Subsystem ID set to 0x0016.
B.7 Ethernet Switch Unit
Based on the variant, PCIE-8120 uses one or two 16-Port SerDes Gigabit Ethernet switch
devices to allow full bandwidth connectivity between all onboard resources.
 Broadcom BCM5396 device, 256-Pin FBGA package.
 16 port 10/100/1000Mbps integrated switch controller.