Artesyn PCIE-8120 Installation and Use (July 2014) - Manual (Page 27)

Hardware Preparation and Installation
PCIE-8120 Installation and Use (6806800R89C) 27
The PCIE-8120 temperature sensors provide alerts about absolute and delta temperature level
on the card. For more information on the default values to set up sensor alarms, see
Sensor Alert
Default Values , Table B-2 on page 74 .
3.3.2 Power Requirements
Before installing the card, make sure that the system is capable to safely deliver the required
power.Typical wattage status is given for the following operating conditions:
Table 3-1 Environmental and Thermal Requirements
Requirement Operating Non-Operating
Temperature 0xC to +55xC -40xC to +70xC
Forced Air Flow recommended >0.5m/s -
Temp. Change +/-0.25xC/min +/-0.25xC/min
Rel. Humidity 5% to 90% non-condensing 5% to 95% non-condensing
Vibration
5 to 200Hz 1g sinusoidal 1g sinusoidal
Table 3-2 Wattage Status
Wattage Status Description
Idle Card powered and is in the default reset state.
Active Power good status on all DSP operations.
Maxload Maximum load test condition (Not achieved during normal operation).
Table 3-3 Power Requirements
PCIE-8120-A12/V12 PCIE-8120-A04/V04 PCIE-8120-A12/V12-N
3.3V current <100mA <100mA <100mA
Typ.Wattage
Idle 20W 12W 20W
Active 35W 15W 32W
Maxload 65W 25W 70W