Artesyn MITX-430/MITX-440-DVI-2E Installation and Use (August 2014) User Manual
Artesyn Equipment
Table of contents
Document Outline
- MITX-430/MITX-440-DVI-2E
- Contents
- About this Manual
- Introduction
- Hardware Preparation and Installation
- 2.1 Environmental and Power Requirements
- 2.2 Board Thermal Management and Placement
- 2.3 Unpacking and Inspecting the Board
- 2.4 Preparing the Installation Environment
- 2.5 Processor Cooler Installation and Removal
- 2.6 Memory Module Installation and Removal
- Controls, LEDs, and Connectors
- 3.1 Board Layout
- 3.2 Connectors
- 3.2.1 Clear CMOS (P3)
- 3.2.2 LVDS Header (J5)
- 3.2.3 LVDS Backlight Header (P23)
- 3.2.4 LVDS Power (P5)
- 3.2.5 MINI IDE Header (J8)
- 3.2.6 USB Flash Header (P10)
- 3.2.7 USB Header (P12)
- 3.2.8 ELO Touch Screen Header (P6)
- 3.2.9 GPIO Header (P4)
- 3.2.10 COM Header (P9, P27)
- 3.2.11 RS-232/422/485 (P18)
- 3.2.12 Power COM (P8, P26)
- 3.2.13 TPM Header (P2)
- 3.2.14 LPT Header (P11)
- 3.2.15 Front Panel Header (P15)
- 3.2.16 BIOS Program Header (P16)
- 3.2.17 Fan Header (P1, P13)
- 3.2.18 MINI PCIE LED (P14)
- 3.2.19 Case Open Header (P25)
- Functional Description
- 4.1 Block Diagram
- 4.2 Pineview-D Processor
- 4.3 SMBus Interface and Devices
- 4.4 System Memory
- 4.5 Ethernet Interfaces
- 4.6 PCI-E Port
- 4.7 USB Interface
- 4.8 VGA, LVDS, LPC, and Audio Interface
- 4.9 DVI Interface
- 4.10 BIOS Device
- 4.11 SPI Flash
- 4.12 GPIO Configuration
- 4.13 Chipset
- 4.14 Clock Generator
- 4.15 Video
- 4.16 Storage
- 4.17 Super I/O
- 4.18 HW Monitor
- 4.19 Watchdog Timer
- 4.20 Debug
- 4.21 Power Management
- 4.22 Manageability
- 4.23 RTC
- Operation
- Operating System and Driver Support
- A Related Documentation
- Safety Notes
- Sicherheitshinweise