beautypg.com

Trigger scpi command subsystem, Calibration scpi command subsystem, Trigger scpi command subsystem -19 – AMETEK SFA Series Programming Manual User Manual

Page 31: Trigger scpi command summary -19, Trigger scpi command reference -19, Calibration scpi command subsystem -19, 11 calibration scpi command subsystem

background image

Sorensen SF Series

IEEE 488.2 and SCPI Command Operation

3.10

3.10.1

3.10.2

TRIGGER SCPI Command Subsystem

TRIGGER SCPI Command Summary

TRIGger
:ABORt
:RAMP
:TYPE

<1|2|3>

TRIGGER SCPI Command Reference

Command Description

SCPI

TRIGger

Trigger subsystem.

C

:ABORt

Clears all settings of voltage and current
upon trigger.

N

:RAMP

Implements current ramping function
previously programmed by the
SOURce:CURRent:RAMP

commands.

N

:TYPe<1|2|3>

Implements current values previously
programmed by the
SOURce:CURRent:LEVel:TRIGger

commands.
Valid arguments are 1 (Not Used),
2 (Current), or 3 (Both).

N

3.11 CALIBRATION SCPI Command Subsystem

See Section 4 for calibration procedures.

WARNING
Please refer to the power supply manual for further information before performing
calibration procedures. Calibration must be performed by qualified personnel who
appropriately deal with attendant hazards. If calibration is not performed properly,
functional problems could arise, requiring that the supply be returned to the factory.

M550292-03 (Programming)

3-19