AMETEK SFA Series Programming Manual - Manual (Page 25)

Sorensen SF Series IEEE 488.2 and SCPI Command Operation
3.6.2 MEASURE SCPI Command Reference
In the following table a "C" in the SCPI column indicates that the command is SCPI-compliant.
Command Description SCPI
MEASure Measure subsystem. C
:CURRent? Returns the floating point value of the DC output
current in amps. C
:CURRent
:AVErage
Enter a value of 1 to 5 to set the number of readings
to average together when returning the current value
from the MEAS:CURR? command. This function
reduces noise in the readback readings. The
(default) value of 1 provides the fastest response
time, but the noisiest readings. N
:AVErage? Returns the number 1 to 5 to indicate the last set
number of readings to average together when taking
a current reading. N
:VOLTage? Returns the floating point value of the DC output
voltage in volts. C
:VOLTage
:AVErage
Enter a value of 1 to 5 to set the number of readings
to average together when returning the voltage value
from the MEAS:VOLT? command. This function
reduces noise in the readback readings. The
(default) value of 1 provides the fastest response
time, but the noisiest readings. N
:AVErage? Returns the number 1 to 5 to indicate the last set
number of readings to average together when taking
a voltage reading. N
M550292-03 (Programming) 3-13