AMETEK SFA Series Programming Manual - Manual (Page 21)

Sorensen SF Series IEEE 488.2 and SCPI Command Operation
Command Description SCPI
*STB? Returns the integer value of the Status Byte with bit 6
representing the Master Summary Status (MSS) instead of RQS.
The MSS bit acts as a summary bit for the Status Byte and
indicates whether the device has at least one reason to request
service based on the MAV and the ESR bits. The Status Byte is
cleared. See section on Status Byte for valid values. Values
range from 0-255.
Response: <0+NR1>
C
*TST? Sets the device to execute an internal self-test and return the
integer value of the results. Value of “0” indicates no errors.
Response: <0+NR1>
C
*WAI Sets the device to wait until all previous commands and queries
are complete before executing commands following the *WAI
command. C
3.5
3.5.1
SOURCE SCPI Command Subsystem
SOURCE SCPI Command Summary
SOURce
:CURRent
:CURRent?
[:LEVel]
[:LEVel?]
[:IMMediate]
[:IMMediate?]
[:AMPLitude]
<0+NRf>
[:AMPLitude?]
:TRIGgered
:TRIGgered?
:CLEar
[:AMPLitude]
<0+NRf>
[:AMPLitude?]
:LIMit
:LIMit?
[:AMPLitude]
<0+NRf>
[:AMPLitude?]
:RAMP
<0+NRf> <0+NRf>
:RAMP?
:ABORt
:ALL?
:TRIGgered
<0+NRf> <0+NRf>
:TRIGgered?
:ONLine?
:STATus
:BLOCk?
:REGister?
:TIMeout?
M550292-03 (Programming) 3-9