Status scpi command subsystem, Status scpi command subsystem -15, Status scpi command summary -15 – AMETEK SFA Series Programming Manual User Manual
Page 27: Status scpi command reference -15

Sorensen SF Series
IEEE 488.2 and SCPI Command Operation
3.8
3.8.1
3.8.2
STATUS SCPI Command Subsystem
Note: See Section 5 for further information.
STATUS SCPI Command Summary
STATus
:OPERation
:CONDition?
:ENABle
<0+NR1>
:ENABle?
:EVENt?
:PRESet
:PROTection
:CONDition?
:ENABle
<0+NR1>
:ENABle?
:EVENt?
:SELEct
<0+NR1>
:QUEStionable
:CONDition?
:ENABle
<0+NR1>
:ENABle?
:EVENt?
STATUS SCPI Command Reference
In the following table a "C" in the SCPI column indicates that the command is SCPI-compliant.
The Q? column indicates whether the command can also be used for querying.
Command Description
SCPI
Q?
STATus
Status subsystem.
C
:OPERation
C
:CONDition?
Returns the integer value of the Operation
Condition Register. The query is supported
but will always return “0” indicating
operational condition.
C
:ENABle <0+NR1>
Sets the enable mask of the Operation
Event Register allowing true conditions to
be reported in the summary bit of the
Operation Condition Register. Values are
written and queried but have no effect on
the Operation Condition Register.
C Q
:EVENt?
Returns the integer value of the Operation
Event Register. This query is supported but
always returns a value of “0” indicating
operational condition.
C
:PRESet
Sets the enable mask of the Operation
Event Register and the Questionable Event
Register to all 1’s.
C
M550292-03 (Programming)
3-15