beautypg.com

AMETEK PLA-PLW User Manual

Page 67

background image

Note: Because the DHCP server assigns a dynamic IP address, the value of the eLOAD IP address maybe different
each time you power on the eLOAD. However, if you intend to remotely control the eLOAD, a static IP address is
more convenient, as the eLOAD IP address does not change, making it easier for remote devices to access the
eLOAD

If your network does not support DHCP server, you must enter the Ethernet settings manually which you obtained
from your network administrator.

Note: The following procedure presumes that your eLOAD has the Ethernet option and you have connected the
eLOAD to your network.

If your network does not support DHCP server, do the following:

1)

Power on the eLOAD

2)

Press the LOCAL key on the front panel, and rotate the encoder

43 to scroll to the “SYSTEM” menu option.

3)

Press ENTER to select.

4)

Choose “ETHERNET” and Press ENTER to select option.

5)

Select “ADDRESS” and press ENTER to select option.

6)

Enter the IP address obtained from your network administrator and press ENTER.

7)

Choose “NETMASK” by rotating the encoder

43 to scroll and press ENTER to select option.

8)

Enter the value obtained from your network administrator and press ENTER.

9)

Choose “GATEWAY” by rotating the encoder

43 to scroll and press ENTER to select.

10)

Enter the default gateway IP address obtained from your network administrator and press ENTER

To Exit, press LOCAL to go back to the start-up screen

USB FUNCTION

The eLOAD also provides a USB remote interface to connect to your computer. You need to install USB driver
included in a CD-ROM shipped with your eLOAD .

After your USB driver is installed, the USB port is converted to a virtual COM port. Refer to the “Verify Installed
USB Driver using Hyper Terminal (Windows XP/2000/98)” section for detailed procedures on how to verify the
USB driver.

Windows XP USB Driver Installation Procedures

Note: You must have administrative privileges to install the USB driver

1)

Connect eLOAD Unit using USB cable

2)

Click on found new hardware bubble (bottom right hand corner of screen)

3-13