AMETEK PLA-PLW - Manual (Page 60)

2. MIN VOLTAGE ---------press ENTER key, input the minimum voltage then press ENTER.
3. MAX CURRENT--------press ENTER key, input the maximum current then press ENTER.
4. MIN CURREN-----------press ENTER key, input the minimum current then press ENTER.
5. MAX RESISTANCE----press ENTER key, input the maximum resistance then press ENTER
6. MIN RESISTANCE-----press ENTER key, input the minimum resistance then press ENTER
7. MAX POWER----------- press ENTER key, input the maximum power then press ENTER
8. MIN POWER------------ press ENTER key, input the minimum power then press ENTER
11. CAL. PARAM.-----press ENTER key, input the MEASURE LOW/ MEASURE HIGH / TRAN. OFFSET, then
press ENTER.
1: LOW MEASURE POINT--press ENTER key, set the low measure count value then press ENTER.
2: HIGH MEASURE POINT-press ENTER key, set the high measure count value then press ENTER.
3: TRANSIENT OFFSET---- press ENTER key, set the transient offset count then press ENTER.
12. OSCILLATE-------press ENTER key, select the OSC. CONTROL/ OSC. DELAY, then press ENTER.
13. BOOT INPUT--------press ENTER key, use
43 to select ON / OFF then press ENTER.
B: Profile Menu - press ENTER key:
*Use 43 to select the next menu setting then press ENTER key to enter the selected menu.
* (Use CLEAR key to back space or to correct the wrong value).
1. RECALL----------press ENTER key, use 43 to select the profile 0/1/2/3 then press ENTER to recall.
2. SAVE----------press ENTER key, use 43 to select the profile 0/1/2/3 then press ENTER to save.
3. RESET---------press ENTER key, then press ENTER to reset.
C: Display Menu - press ENTER key:
*Use 43 to select the next menu setting then press ENTER key to enter the selected menu.
* (Use CLEAR key to back space or to correct the wrong value).
1. METER MODE---press ENTER key, use 43 to select display mode (V+I, V+P, V+C, V+R, I+P, I+C, I+R,
R+P, R+C, P+C, V+T, I+T, R+T, P+T, C+T) then press ENTER.
2. ‘C’ Value------press ENTER key, then input the C value in Ampere.
D: System Menu - press ENTER key:
*Use 43 to select the next menu setting then press ENTER key to enter the selected menu.
* (Use CLEAR key to back space or to correct the wrong value).
1. GPIB ADDRESS--press ENTER key, use 43 to set the GPIB address ( 0 – 31 ) then press ENTER.
2. RS-232 SPEED----press ENTER key, use 43 to set the BAUD RATE ( 2400 – 115200 ) then press ENTER.
3. SYNTAX MODE--press ENTER key, use 43select the syntax mode (PEL or PLW/PLA) then press ENTER
4. EOS CODE----------press ENTER key, use 43 to set end of interface code then press ENTER.
5. BUZZER-----------press ENTER key, use 43 to select ON / OFF then press ENTER.
1: LOW MEAS POINT 432: HIGH MEAS POINT 433: TRANS OFFSET
1: RECALL 432: SAVE 43 3: RESET
1: Meter Mode 432: ‘C’ Value
1: GPIB ADDRESS 432: RS-232 SPEED 43 3: SYNTAX MODE 434: EOS CODE 43 5: BUZZER
43 6: PANEL LOCK 437: ETHERNET
3-6