AMETEK PLA-PLW - Manual (Page 21)

Front Panel Keypad Description
FIGURE 1.2 FRONT PANEL KEYPAD
Key “0” Numeric entry key for number 0.
Key “.” Numeric entry key for decimal dot.
Key “1” Numeric entry key for number 1.
Key “2” Numeric entry key for number 2.
Key “3” Numeric entry key for number 3.
Key “4” Numeric entry key for number 4.
Key “5” Numeric entry key for number 5.
Key “6” Numeric entry key for number 6.
Key “7” Numeric entry key for number 7.
Key “8” Numeric entry key for number 8.
Key “9” Numeric entry key for number 9.
Key “CLEAR” Clears partially set commands and
return the unit to the metering mode. By
pressing the "Clear" with no entry will
display "AMREL Model number and
software version.
Note: If the model name exceeds 16 digits, the displayed
model name will truncate. Please refer to the model name
label or use *IDN? Command to query back model name
Key “RANGE” Selects between auto, manual low,
manual middle and manual high range.
Key “LOCAL” Returns from remote PC control to local
operation and status indicator will
change from RMT to LCL. The Local
key also accesses all eLOAD menu
options and parameters for configuring
desired settings.
Key “STEP” Allows programming of time duration
and value settings for step operation
Key “ENTER” Enters the values in the set mode and
returns the unit to the metering mode.
Hot Key Description
HOT KEYS OFF SOLID ON FLASHING ON
INPUT INPUT OFF INPUT ON Press to Short
SHORT SHORT OFF SHORT ON Press to Short
STEP STEP OFF STEP ON Press Input to Start Step
PULSE PULSE OFF PULSE ON Press Input to Start Pulse
CC CC Mode Disabled CC Mode Enabled N/A
CR CR Mode Disabled CR Mode Enabled N/A
CP CP Mode Disabled CP Mode Enabled N/A
19CV CV Mode Disabled CV Mode Enabled N/A
CONT Continuous Disabled Continuous Enabled N/A
TOGGLE Toggle Disabled Toggle Enabled N/A
SINGLE Single Disabled Single Enabled N/A
TRIGGER N/A N/A Trigger Transient Operation
PEAK Setting not Enabled Adjust Trans. Value N/A
FREQ Setting not Enabled Adjust Trans. Freq. N/A
DUTY Setting not Enabled Adjust Trans. Duty N/A
SLEW Setting not Enabled Adjust +/- Slew Rate N/A
TABLE 1.2 – HOT KEY DESCRIPTION
MENU
7 8 9 LOCAL
4 5 6 RANGE
1 2 3 STEP
0 x CLEAR ENTER
1-11