Xtramus NuBAR-1000 V1.4 - Manual (Page 8)

7
E-mail: [email protected]
Website: www. X tramus.com
XTRAMUS TECHNOLOGIES ®
Status LED
Type Label LED Description
System Power
(Run) ON System is ready
Blinking System is running the specified task
OFF Power is off
Battery ON Battery is almost exhausted. Please
connect USB cable to charge it.
Test result CRC ON CRC Error is found during the test
Blinking Keep blinking if CRC error packets are
received continually.
Tx loss ON Packet loss is found from local to
remote side during the test.
Rx loss ON Packet loss is found at receiving side
from remote to local side during the
test.
Fail ON Result of the test is failed.
Pass ON Result of the test is passed.
Functional Status
(Loopback)
ON Loopback status is enabled. Rotate
functional rotary switch to 8 or 9 mode
to enable this status
OFF Under normal Lord or Servant mode.
Servant ON This device is under Servant Mode.
Rotate functional rotary switch to this
mode.
OFF This device is under Lord Mode.
(Connect)
ON Negotiation and connection between
Lord unit and Servant unit is
successful.
Slow blinking
(1Hz) Request connection to Lord unit or
Servant unit. If the unit is under Lord
mode, then it request connection to
Servant, and vice versa.
Fast blinking
(8Hz) Request connection between Lord unit
and Servant unit is failed.
Get IP ON Test the connection to Internet is
successful.