Xtramus NuBAR-1000 V1.4 User Manual

Page 47

Website: www.

tramus.com

XTRAMUS TECHNOLOGIES



Stop: Stop Packet Generation



Start: Start Packet Generation



Pause: Pause the procedure



Resume: Resume to original procedure



Clear: Clear all counter for next test

: Time (sec): Duration of ongoing test

: Packet Length: packet length available for the test, from 64 to 1518 bytes, plus random length

selections

: Transfer Rate (Mbps): The transmission throughput in Mbps. Please input value that fit the

real network environment; otherwise, packet loss would happen.

: Payload(0x): Contents in hexadecimal mode carried in Ethernet frame (packet). In the

selections



Fixed value: 0000, FFFF, 5A5A, 55AA, 0F0F, 00FF. These values are repeated continually

until the end of the test



Byte increase: Byte of payload in frame is increasing



Random: The payload contents are generated randomly by the device.



BERT: Bit Error Rate Test is a testing method for digital communication circuits that uses

predetermined stress patterns comprising of a sequence of logical ones and zeros

generated by a pseudorandom binary sequence.

: Test Time (sec): Test duration of a single test.

: Destination MAC: Destination MAC address that this NuBAR-1000 will transmit packet for

test.

: Source MAC: Source MAC address. It should be the MAC address of this NuBAR-1000

: VLAN: Tick to add VLAN tag in the packet (frame). When this option is selected, specify

: VID (VLAN ID) for the VLAN tag.

: IP: IP address in IP header of payload in Ethernet packet (frame)

: Destination IP: Destination IP address of the packet

: Source IP: Source IP address of the packet. It should be the IP address of this NuBAR-1000

itself.