Xtramus NuBAR-1000 V1.4 - Manual (Page 50)

49
E-mail: [email protected]
Website: www. X tramus.com
XTRAMUS TECHNOLOGIES ®
Force mode includes 10Mbps full duplex only.
E : Packet Length: packet length available for the test, from 64 to 1518 bytes
F : Transfer Rate (Mbps): The transmission throughput in Mbps. Please input value that fit the real
network environment; otherwise, packet loss would happen.
G : Test Time (second): Test duration of a single test.
H : Apply: Click to take effect the configuration
Command
I : The default test speed is 1000Mbps Full
J : Test Time (second): The duration in seconds that is going on currently. The parameter of
duration can be configured at the time rotary switch on the panel of NuBAR-1000.
K : Button to control the procedure
 Stop (button): Stop the test. If Test Time (second) is configured. Wait the system to stop the
test automatically, otherwise, force to stop the test immediately get the failed test result.
 Start (button): Start the test.
L : Transmit Counter from Lord NuBAR-1000 in symmetric loop test.
M : MAC: MAC address of Lord NuBAR-1000
N : Tx Rate: Transfer rate of ongoing test stream.
O : Tx Maximum Rate: Maximum transfer rate of ongoing test stream.
P : Tx Packet: Transmitted packet counts
Q : Tx Byte: Transmitted data bytes.
R : Received Counter at Servant NuBAR-1000 in symmetric loop test.
S : MAC: MAC address of Servant NuBAR-1000
T : Rx Rate: Receive rate from ongoing test stream generated from Lord NuBAR-1000.
U : Rx Packet: Received packet counts
V : Rx Byte: Received data bytes.
W : CRC Error: CRC error packet counts found from received packet
X : Packet Loss: Packet loss counts found in received packets.
A1 : Transmit Counter from Servant NuBAR-1000 to Lord NuBAR-1000 in symmetric loop test.

Tx Rate: Transfer rate of ongoing test stream.

Tx Packet: Transmitted packet counts