Xtramus NuBAR-1000 V1.4 - Manual (Page 20)

19
E-mail: [email protected]
Website: www. X tramus.com
XTRAMUS TECHNOLOGIES ®
When user clicks Start / Run button to start the test, the NuBAR-1000 stops automatically for a
moment later, owing to the test duration configured here. If test duration is configured, wait result
until the test is done. Press Stop button to stop the test immediately will cause a fail test.
If it is configured to "0", the test keeps going continually, unless user press Stop button to stop
the test.
3.2 Button for Operation
There are 3 buttons for the operation of NuBAR-1000. When configuration via rotary switch is
done, press these buttons to operate the function for the test.
3.2.1 Run / Stop button
Press it to start the procedure configured in Rotary Function Switch. The procedure will stop
automatically, owing to the internal settings of the procedure or the duration configured at Rotary
Test Duration Switch.
Force to stop the procedure by pressing it again. For most of test procedures, they will stop
automatically. Force to stop these tests probably cause failed result.
Clear
Tx Test
Run / Stop