Configure tftp settings – Pointmaker CPN-5800 User Manual
Page 72

Page 66 -
Pointmaker CPN-5800 Live Streaming Annotation System
Pointmaker LLC.
Multipoint
Section Three: CPN-5800 Menu System
3. Exit the menu system.
You can now interactively mark over any displayed images.
OR:
4. If you wish to exit a meeting you have joined, select EXIT MEETING.
You are disconnected from the meeting. You may select a different menu
option or exit the menu system
Configure TFTP Settings
The Pointmaker TFTP feature gives you the ability to save and retrieve images
using the TFTP protocol. To save a file using TFTP, you must first install a TFTP
server on the computer which will receive the file(s). There is a free TFTP server
available from solarwinds.com which has been tested successfully with the
CPN-5800. You will need the IP address of the server where TFTP is installed. It’s
also important to make sure your firewall does not block it.
The following steps are required to allow the unit to communicate with the
computer where TFTP has been installed and set up.
1. Activate the menu system
(see Activating the Menu, on page 29).
The Main Menu appears (see Figure 3-1, Main Menu, on page 30.)
2. Select the NETWORK option.
The Network Menu appears (see Figure 3-31, on page 61).
3. Select the TFTP option.
Figure 3-36: TFTP Setup Dialog