Pointmaker CPN-5800 - Manual (Page 15)

Pointmaker LLC Pointmaker CPN-5800 Live Streaming Annotation System - Page 9
Section One:Getting Started Controllers/Markers Overview
C
ontrollers
/M
arkers
o
verview
This section introduces you to the most common devices you might use with the
CPN-5800. The CPN-5800 supports up to two RS-232 devices and up to 10 USB
devices through the addition of powered USB hubs.
IMPORTANT: Be sure to power down the Pointmaker before connecting or
disconnecting any controllers. The Pointmaker auto matically detects installed
controllers upon power up.
DTU-30 Digitizing Tablet
The Pointmaker DTU-CTL470 Digitizing Tablet is optional for the CPN-
5800
(tablet design may vary). In general, the tablet is used to draw, position
point ers or make menu selections. The position and movements of the stylus (also
called a pen) are represented by a video pointer on whatever display devices are
activated. Additionally, most setup commands can be activated using the tablet
rather than entering the on-screen menu system (see Using the CPN-5800 Menu
System, on page 29.
Refer back to this section, if needed, for general instructions concerning the
tablet’s operation.
Figure 1-3: DTU-CTL470 Digitizing Tablet Overview
a
Ctive
a
rea
The maximum area on the Pointmaker digitizing tablet that responds to the stylus.
This area includes the Menu Strip, as well as the Track ing Area.