Pointmaker CPN-5800 - Manual (Page 25)

Pointmaker LLC Pointmaker CPN-5800 Live Streaming Annotation System - Page 19
Section Two:Installation Connecting Controllers
DVI-D Connectors (through HDMI)
1. If desired, use a HDMI to DVI-D video cable to connect the Pointmaker
HDMI INPUT or OUTPUT connector to a DVI display device.
Connecting Controllers
1. The following categories of controllers can be used with the CPN-5800:
• KB-30 Keyboard
• Touch Screens/Electronic
Whiteboards
• DTU-CTL470 Digitizing Tablets
• Mouse devices
• iPads
Here are some guidelines for setting up these devices.
IMPORTANT: Be sure to power down the Pointmaker before connecting or
disconnecting any controllers. The Pointmaker will automatically detect the
installed controllers upon power up. If you change controllers or add a new
controller, you need to power down, install the new controller(s), then power
up.
Figure 2-2: Cntroller Ports - Rear
Figure 2-4: Controller Ports - Front