Drylam Fujipla PLS3311 - Manual (Page 44)

AL-MEISTER PLS3311 INSTRUCTION MANUAL
【 CUT ONE WAY 】
Blade does cutting from operation panel side only and goes back to the ready position on the
operator side of the machine. This mode applies to the paper which has fewer margin than 0.12”
at the opposite side. NOTE ・The paper must be positioned on the Feeder Tray so that the wider
margin is on the operator side.
4
Choose [1] or [2] by pressing [UP] or [DOWN] key.
5
Press [MODE] key to confirm.
The display returns to the initial display or the warm-up display when no keys are pressed for 5
seconds.
NOTE
• One way cutting will always start from the operation side. When the blade is at the
opposite side (non-operator side) it will move back to the operation side when this mode
is selected.
• This setting is not retained in memory after power off.