Drylam Fujipla PLS3311 - Manual (Page 30)

AL-MEISTER PLS3311 INSTRUCTION MANUAL
NOTE CURRENT TEMPERATURE
Press [TEMP/SPEED] to confirm.
The temperature also confirms if [TEMP/SPEED] key is not pressed for 10 sec. The display returns
to the initial display or the warm-up display.
When the set temperature is 140°F, press DOWN scroll key, and the display shows “OFF”.
5-2. SET SPEED
1
Press [TEMP/SPEED] key two (2) times.
This display appears.
NOTE
• The default is the set speed stored in a microchip in the film core.
2
Press [UP] or [DOWN] scroll key to set speed. Speed can be set by 4”/min increments. The speed
display blinks.
3
Press [TEMP/SPEED] key again to confirm. The speed also confirms if [TEMP/SPEED] key is not
pressed for 10 seconds.
The display returns to the initial display or the warm-up display.