Drylam Fujipla PLS3311 - Manual (Page 29)

AL-MEISTER PLS3311 INSTRUCTION MANUAL
5．CHANGE SETTINGS
5-1. SET TEMPERATURE
1
Press [TEMP./SPEED] key. This display appears.
NOTE:
• The default is the set temperature stored in the film.
2
Press [UP] or [DOWN] scroll key to set temperature. Temperature can be set in 5 or 10°F
increments. The temperature display blinks during set mode.
3
Press [TEMP/SPEED] to confirm. The temperature also confirms if [TEMP/SPEED] key is not
pressed for 10 sec. The display returns to the initial display or the warm-up display. When the set
temperature is 140°F, press DOWN scroll key, and the display shows “OFF”.