Drylam Fujipla PLS3311 - Manual (Page 16)

AL-MEISTER PLS3311 INSTRUCTION MANUAL
3-3. SET REAR EXIT TRAY
Remove the knob screw from the rear exit tray.
Apply Exit Tray Guard and fasten the knob
The picture shows the rear exit tray installed in its correct position.
1 Hold the rear exit tray with both your hands.
Fit it as shown in the illustration. Make sure that the Exit Tray is securely
attached.
2 The Rear Exit Tray can be adjusted in two positions (high/low) with three different angles each.
Select the appropriate position for the paper used. (A) and (3) for thin paper (B) and (1) for thick
paper.