Dataman 48XP - Manual (Page 11)

11
LED Display
The DATAMAN-48XP has a three LED display to indicate the
status of the socket. Read this section carefully to avoid
possible damage to chips.
Warning: Do not insert or remove a device from the socket
while the yellow ’Busy’ LED is on!
Green LED on (Good) the last operation was successful.
Yellow LED on (Busy) The socket is busy; do not insert or
remove devices from the ZIF socket
before green LED or red LED is on.
Red LED on (Error) the last operation resulted in failure.
Flashing LED at 5Hz frequency. This only applies to mass
production mode. The chip has passed the program and
verify cycle and is waiting for the operator to remove it and
insert a new one.
File Commands
Save Buffer to File
Menu File / Save Buffer
Hot key Alt-S
This option is used to save the memory buffer to a file on the
hard disk. Select a file using the mouse, or type a filename in
the box provided. You can also type in a file extension. (e.g.
*.hex) at the ‘Name’ prompt. This will display all the files of
the specified type. You can then select the required file to
overwrite.