BINDER VD 23 - Manual (Page 70)

VDL (E2.1) 04/2014 page 70/107
Press key
Display 1 shows 0000 (no function)
Display 2 shows Protocol: MODBUS (Selection of interface mode)
(actual setting: Modbus)
Select between protocols “MODBUS” and
“Printer” using arrow keys
Setting is shown in display 2.
Press key
Display 1 shows e.g. 3 (actual setting: 3 min)
Display 2 shows Prt-Inv.
3
(print interval)
(actual setting: 3 min)
Select value between 0 and 255 minutes
using arrow keys
Setting is shown in displays 1 and 2.
Press key
Display 1 shows 0000
Display 2 shows Disp.LED:
No
(continuous display illumination?)
(actual setting: No)
Select between “Yes” and “No” using arrow
keys
Setting is shown in display 2.
Press key
Display 1 shows 0000
Display 2 shows
PrgSelec: 2Prg10S
(1 program with max. 20 sections or
2 programs with max. 10 sections each?)
(actual setting: 2Prg10S)
Select between “2Prg10S” and “1Prg20S”
using arrow keys
Setting is shown in display 2.
Press key
Display 1 shows 0000
Display 2 shows Prg.Time: 99:59 (max. section length 99:59 or 999:59?)
(actual setting: 99:59)
Select between 99:59 in hh:mm or 999:59 in
hhh:mm using arrow keys
Setting is shown in display 2.
Press key
Display 1 shows 0000
Display 2 shows
Setp.sim Ramp
(ramp or step?)
(actual setting: ramp)
Select between Ramp and Step using arrow
keys
Setting is shown in display 2.
Press key
Display 1 shows 0000
Display 2 shows Tol.band
0
(Tolerance limits in °C)
(actual setting: 0)
Set value in °C using arrow keys Setting is shown in display 2.
Press key
Display 1 shows 0000
Display 2 shows Prog.Clk Inactive (Week program timer active or inactive?
(actual setting: Inactive)