Altera MAX 10 Embedded Multipliers - Manual (Page 11)

• Filter IP Catalog to Show IP for active device family or Show IP for all device families.
• Search to locate any full or partial IP core name in IP Catalog. Click Search for Partner IP, to access
partner IP information on the Altera website.
• Right-click an IP core name in IP Catalog to display details about supported devices, installation
location, and links to documentation.
Figure 3-1: Quartus II IP Catalog
Search and filter IP for your target device
Double-click to customize, right-click for information
Note: The IP Catalog and parameter editor replace the MegaWizard ™ Plug-In Manager in the Quartus II
software. The Quartus II software may generate messages that refer to the MegaWizard Plug-In
Manager. Substitute "IP Catalog and parameter editor" for "MegaWizard Plug-In Manager" in these
messages.
Specifying IP Core Parameters and Options
Follow these steps to specify IP core parameters and options.
1. In the IP Catalog (Tools > IP Catalog), locate and double-click the name of the IP core to customize.
The parameter editor appears.
2. Specify a top-level name for your custom IP variation. This name identifies the IP core variation files
in your project. If prompted, also specify the target Altera device family and output file HDL
preference. Click OK.
3. Specify parameters and options for your IP variation:
3-2 Specifying IP Core Parameters and Options
UG-M10DSP
2014.09.22
Altera Corporation Embedded Multipliers Implementation Guides
Send Feedback