Pilz PSSu H SB IBSo - Manual (Page 35)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
8-1
8.1 Technical details
8 Technical details
8 8000 Technical details Technical details 8- 8.1 Technical details 8100 Technical details 8- ][Technische Daten PSSu Kopf SBUS+ST-BUS oZust
Technical details
Application range Standard/Failsafe
Maximum achievable category in accordance with
EN 954-1 4
Maximum achievable SIL value SIL3
Module's device code 0225h
Electrical data
Internal supply voltage
Supply voltage range of module supply
4.9 - 5.1 V
Current and power consumption from module supply
Module's current consumption without FO connection
480 mA
FO connection's current consumption 120 mA
Module's power consumption without FO connection 2.40 W
FO connection's power consumption 0.60 W
Max. power dissipation of the module 2.40 W
Potential isolation between module supply and
INTERBUS
700 V
Potential isolation between module supply and
SafetyBUS p 700 V
SafetyBUS p
Application range
Failsafe applications
Device address 32d ... 95d
Max. transmission rate 500 kBit/s
Cable runs 3,500 m
Transmission type differential two-wire cable
Connection Male 9-pin D-SUB connector
INTERBUS
Application range
Standard applications
Device type Slave
Maximum data length of the fieldbus interface: Input 64 Byte
Maximum data length of the fieldbus interface: Output 64 Byte
Maximum data length of the fieldbus interface: Diagnostics 4 Byte
Transmission rates
2 MBit/s, 500 kBit/s
Set via DIP switch
Connection F-SMA connector
Protocol INTERBUS-Protokoll
Operating modes Slave Mode
Manufacturer's ID 248h
USB
Connection
Mini-B connector
Environmental data
Climatic suitability
EN 60068-2-14, EN 60068-2-1, EN 60068-2-2,
EN 60068-2-30, EN 60068-2-78
Ambient temperature 0 - 60 °C
Storage temperature -25 - 70 °C
Climatic suitability in accordance with EN 60068-2-78 93 % r. h. at 40 °C
Condensation no
EMC EN 61000-4-2, EN 61000-4-3, EN 61000-4-4,
EN 61000-4-5, EN 61000-4-6, EN 61000-6-2,
EN 61000-6-4