Pilz PSSu H m F DPsafe SN SD - Manual (Page 14)

Function description
Operating Manual PSSu H m F DPsafe SN SD
1002933­EN­02 14
INFORMATION
Further information on SafetyNET p can be found in the "PSS 4000 System
Description".
4.7 PROFIBUS­DP with PROFIsafe
4.7.1 Connection to PROFIBUS DP with PROFIsafe
PROFIBUS is an open fieldbus standard whose communication is defined in the interna­
tional standards IEC 61158 and IEC 61784. Further provisions have been defined in spe­
cifications published by the PROFIBUS User Group. These specifications are available
from PROFIBUS International (see www.profibus.com).
The head module has a PROFIBUS­DP interface with PROFIsafe. Communication via
PROFIsafe is defined in the international standard IEC 61784­3­3.
4.7.2 Selector switch for setting the station address
} The station address of a PSSu is set via the "ADDRESS" DIP switch. The DIP switch is
binary coded. Permitted station addresses are in the range 0
D
... 125
D
. If station ad­
dress 126
D
is set via the DIP switch, the address can be assigned via the Master. The
Set Slave Address command (SSA) must be run for this purpose.
} The station address of an F­device is set via the "F­ADDRESS" DIP switch. The DIP
switch is binary coded. Permitted station addresses are in the range 1
D
... 511
D