Pilz PNOZ ms1p standstill / speed monitor - Manual (Page 14)

3.3 Safety regulations
3 Safety
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
3-4
3.3 Safety regulations 3300 Safety regulations 3- 3.3.1 Use of qualified personnel
Use of qualified personnel 3-
The products may only be assembled, installed, programmed, commis-
sioned, operated, maintained and decomissioned by qualified person-
nel. Qualified personnel are people who, because they are:
` Qualified electrical engineers or
` Have received training from qualified electrical engineers
are suitably experienced to operate devices, systems, plant and ma-
chinery in accordance with the general standards and guidelines for
safety technology.
It is the company's responsibility only to employ personnel who:
` Are familiar with the basic regulations concerning health and safety /
accident prevention
` Have read and understood the safety guidelines given in this descrip-
tion
` Have a good knowledge of the generic and specialist standards appli-
cable to the specific application.
3.3.2 Warranty and liability
Warranty and liability 3-
All claims to warranty and liability will be rendered invalid if:
` The product was used contrary to the purpose for which it is intended
` Damage can be attributed to not having followed the guidelines in the
manual
` Operating personnel are not suitably qualified
` Any type of modification has been made (e.g. exchanging compo-
nents on the PCB boards, soldering work etc.).
3.3.3 Disposal
Disposal 3-
The product must be disposed of properly when it reaches the end of its
service life.
3.3.4 For your safety
For your safety 3-
The unit meets all necessary conditions for safe operation. However,
you should always ensure that the following safety requirements are
met:
` This operating manual only describes the basic functions of the unit.
Information on the advanced functions can be found in the online help